What is the best way to clean?!
Question: What is the best way to clean!?
a bridge I have, I floss teeth but am afraid to unsettle the bridge!.Www@Answer-Health@Com
Answers:
Brushing is one of the first steps to take care of a fixed bridge!. A soft bristle toothbrush with a small head should be use to scrub the sides of the bridge!.
To clean underneath the fixed bridge (the space between the artificial tooth and gum tissue), you need to use a floss threader!. A floss threader is a small nylon needle-like, flexible loop , used for you to guide the floss or dental tape!.
How To Use A Floss Threader:
1!. Take a floss threader and thread the loop end with a piece of dental floss or dental tape about 20 inches long, leaving one end shorter than the over!.
2!. Push the straight end of the threader gently through the space between the artificial tooth and the gum tissue towards the tongue!.
3!. Reach inside to mouth, grasp the protruding end of the threader and pull the floss through until the short end is exposed, then slide the loop off the floss!.
4!. Maintain a short span of floss between the fingers as you guide it along!. This will give you better control of the floss and lesson the possibility of hitting or injuring the gum tissue!.
5!. Move the floss gently between to gum tissue and artificial tooth with light pressure against the artificial tooth!. Then move the floss against the side of one of the teeth, which is holding the bridge and repeat the procedure!.
6!.Pull the floss out using the same grip!. Then work floss between one of the teeth holding the bridge and the tooth next to it!.
7!. After you have finished flossing, place a small amount of water in your mouth and swish it around the teeth very forcefully to remove any food particles that may had been left in the mouth!.Www@Answer-Health@Com
To clean underneath the fixed bridge (the space between the artificial tooth and gum tissue), you need to use a floss threader!. A floss threader is a small nylon needle-like, flexible loop , used for you to guide the floss or dental tape!.
How To Use A Floss Threader:
1!. Take a floss threader and thread the loop end with a piece of dental floss or dental tape about 20 inches long, leaving one end shorter than the over!.
2!. Push the straight end of the threader gently through the space between the artificial tooth and the gum tissue towards the tongue!.
3!. Reach inside to mouth, grasp the protruding end of the threader and pull the floss through until the short end is exposed, then slide the loop off the floss!.
4!. Maintain a short span of floss between the fingers as you guide it along!. This will give you better control of the floss and lesson the possibility of hitting or injuring the gum tissue!.
5!. Move the floss gently between to gum tissue and artificial tooth with light pressure against the artificial tooth!. Then move the floss against the side of one of the teeth, which is holding the bridge and repeat the procedure!.
6!.Pull the floss out using the same grip!. Then work floss between one of the teeth holding the bridge and the tooth next to it!.
7!. After you have finished flossing, place a small amount of water in your mouth and swish it around the teeth very forcefully to remove any food particles that may had been left in the mouth!.Www@Answer-Health@Com